Tach

Troubleshooting started by Robert · 5 h ago
5 h ago

I have a universal diesel m35. Tach is a dial type but electric impulse driven. I might be might be missing it but is there a recommended connection to the original tach? Will it affect other rpm readings if connected? Thanks again.

5 h ago

If your alternator has a stator tap, that is the best place to connect the RPM wire (Cable 1, Pin 4, blue wire). On the alternator the post is usually marked W, STA, Stator, or AC. If it does not exist or you can't reach it, you can connect to the signal going to your electric impulse tach as long as the voltage stays less than 100 V. Trace that tach wire back if you can: if it ends at the alternator, it is the stator tap anyway (common), and you can join it at whichever end is easier to reach.

Connecting it will not change the tach reading. The regulator's input draws less than a milliamp from that signal.

Reply to this thread