I have what is probably common - a two battery bank boat. House and starting. The starting battery is flooded chemistry and the House is two battle borns replacing flooded. I have a balmar alternator (70a) and a palmar 618 regulator which is set up for lithium charging. It is a bit wonky and cuts in and out and I'd like to replace it. Suggestions as to set up with your unit which interests me. Thanks
Two Battery Banks
Hi Robert, the XREG-010 would be a direct upgrade for the balmar 618, providing better transparency and control, along with the other advantages shown here: https://xengineering.net/#compare
A couple questions: 1) Do you have a battery shunt on your house bank already? If not, I'd recommend installing that at the same time as XREG. 2) Do you have a DC/DC charger between your lithium bank (charged directly by the alternator) and starting battery? If so, that's the same setup I have on my boat, and it works well. The DC/DC charger does not need to be large, pretty much any on the market will keep the starter battery topped up.
Thanks for the suggestions. I do have a victron shunt in place - I had been thinking dc to dc charger but or the house bank. Your idea of that for the start battery makes more sense. What do you use for the battery switch. ? Where do you feed the b2b from? You said directly from the alternator - do you split the line so it also feeds your house bank?
With the shunt already in place it saves you some effort, would wire like this, let me know if not clear:
Thanks. That is clear for me. Other question was recommendation for battery switch ... I have an old A/B/both. Probably OK but I think there might be better. Am asking around.
If your A/B/Both switch also has an Off position (most do), then it's the same as my setup. House bank on A, starter battery on B. (or vice versa), and the switch's common (COM) terminal to the positive bus. Leave switch on A in normal use. "Both" connects the two batteries together, which is useful for jump starting a dead house bank, or the other way around. The jump start isn't gentle on either battery, because nothing limits the current between the banks except the cables and the batteries themselves, so use it only in emergencies. In my case the cables were long enough that it worked, but, be careful! Updated drawing attached.
Thanks for all the info. Helpful.
And the graphics are a good job for explaining. Best Wishes Rober

